![]() Then, 18 red lights are set to irradiate with a biophotonic sensor with an applied light intensity between 0 and 100%. Six red LEDs of a wavelength of 660 nm in a circle around each cell allow the treatment to proceed according to the diagnostic result based on the impedance signal value and position of the affected area. The corrected signal value, obtained by calculating the change between the impedances of the oscillation and receiving pins for each cell, is stored on the server. Figure 1a shows the arrangement of the pins, and Figure 1b shows the top view of the PUCD. Accordingly, a total of 18 impedance values are calculated from three cells. The components of the PUCD are as follows: the pins responsible for impedance oscillation are each surrounded by six pins responsible for receiving the biopotential signal. ![]()
0 Comments
Leave a Reply. |